Before you can work with any printer in the 3D Lab, you need to get a basic introduction.
Check the calendar to see when the next introduction is going to happen, they are typically scheduled on Wednesdays.
If you would like to use something not covered by the basic introduction, like a specific printer or a special filament, the people in the list below are authorized to give you the necessary introduction.
Get in touch with one of them directly or via the x-hain 3D-Lab Matrix channel.
| Name | Matrix |
|---|---|
| akin | @akin |
| tig3rch3n | @tig3rch3n |
| m0le | @m0le |
| tobi | @lev |
| ralf | @greencomet |
| claire | @claire |
| michael | @mweinberg |
| ames | @ananaphasia |
| patryk | @patryk |
| carlo | @kaemex |