DO NOT use the Thicknessing planer without having received instructions and official permission from an authorized person.
When working on the thickness planer, there is a high risk of risk of workpiece kickback, as the cutterhead operates in works in the opposite direction to the workpiece feed. There is a risk of splintering workpiece parts being parts could be ejected and injure the machine operator. injure the machine operator.
The reasons for this are:
- Simultaneous processing of more than 2 workpieces on a machine equipped with a rigid feed roller and a rigid pressure beam.
- a blade protrusion of more than 1.1 mm.
- running up with workpieces on the machine table, resulting in "insert milling" and subsequent workpiece kickback.
¶ Thicknessing planer
Please read the Space Rules first, especially the sections on "safety" and "use of machinery".
This page is intended as a reminder and does NOT replace a personal introduction to the Thicknessing plane.
If you break the rules layed out on this page, your permission can be revoked.
- contact: Please ask in the #hobelhoehle channel to receive a personal introduction
¶ Overview
- Manual: Manual Planer PDF
- Thickness planing machines are used to plane wooden workpieces to specific thicknesses and to produce thicknesses and for producing smooth, even and parallel surfaces after the workpieces after dressing. During processing, the workpiece is by feed rollers, fed to the cutterhead, which is usually located above the machine table cutterhead, usually located above the machine table, and transported further by feed rollers.
- Cutting width: 304 mm
¶ Safety gear required
- Hearing protection (for everyone in the room)
¶ Safety instructions
- Only workpieces that are longer than the centre distance between the infeed and outfeed roller may be processed.
- area of flying workpieces and workpiece parts observe for all persons.
¶ Setup
- Ensure that the appliance is securely positioned
- fold down both shelves
- Install the extraction bonnet
- connect the hoover, best possible, at the moment there is no really suitable adapter.
- connect the appliance to the socket of the hoover
- As soon as the pin, which is located in the centre of the front, rests on the workpiece, the height is set to this workpiece and can be reduced using the table. For hardwood, halve the value. Adjustable via the upper lever.
- Start the device and insert the workpiece carefully, use all areas so that the blades are not only worn in the centre.
- do not process more than two workpieces at the same time, one on the left and one on the right, as the machine has no anti-kickback device!
- Only adjust the height of the machine table when there is no workpiece in the machine.
- Make sure there is sufficient space behind the machine for the workpieces to be dispensed.
¶ Clean up
- Vacuum up any waste
- Return mashine
- Return safety gear
¶ Shortcuts
- Hobelhöhle
- Circular saw For ripping timber in fibre direction and panel materials
- Miter saw cuts timber and boards to length with angles of 90-45°
- Band saw for curved cuts or rough cutting of timber
- Thicknessing planer Makes timber thinner
- Drill press Makes holes in pretty much everything
- Lathe This is our lathe. There are many others like it, but this one is ours.
- CNC Does what the computer says
- Tormek Wet grinding machine for tool sharpening
Short URL: https://t1p.de/uwngv